Wall & Floor Flange - Long Neck - Anthracite Finish

Wall and Floor Flange - Long - Anthracite - Bar Rail

Long Neck Flange Fixing with PVD Coated Anthracite Finish for 38.1mm Diameter Tube

Wall/floor flange with very dark grey (near black) finish designed for tube to be mounted over the long neck to provide a secure termination of 38.1mm diameter bar rail tube sections.

Wall/Floor Flange - Long Neck - Anthracite

Wall/Floor Flange - Long Neck - Dimensions

Wall/Floor Flange - Long Neck - Cross Section

Wall/Floor Flange - Long Neck - Position

Wall and Floor Flange Fixing - Long Neck - Bar Railing

Options	Finish	Tube Ø (mm)	D (mm)	H (mm)	Material	Code	Price (inc VAT)	Quantity
38.1mm Ø	Anthracite Black	38.1	75	40	Zamak	11.0504.038.26	£13.78	In stock

Tip: To view the product code and full product table on mobile please tilt your device to landscape.

Key Features :

	Anthracite black design.
	PVD coated Zamak construction.
	To fit 38.1mm diameter tube.
	Tube can be attached using High Strength Fixative.
	For installation you will require a few simple household tools.

Stylish flange fixing suitable for horizontal and vertical use, tube fits neatly over the long neck and can be secured in to position using a high strength adhesive.

Available for 38.1mm (1.5 inch) diameter tube.

Manufactured from Zamak with a PVD coated Anthracite finish.

Suitable for indoor use.

Three countersunk fixing points for quick and easy attachment to flat surfaces.

Can be mounted on to a multitude of surfaces if combined with the relevant fixings.

Zamak Construction - PVD Coating

Zamak is a family of alloys with a base metal of zinc with elements of aluminium, magnesium and copper.

PVD (Physical Vapour Deposition) coatings are usually harder and more corrosion resistant than coatings applied by electroplating and tend to have high temperature and good impact strength, excellent abrasion resistance and durability.

Installation Advice

Our installation example below is for a bar foot rail using adhesive for a secure fixing.

Note: It is possible to attach tube without the use of high strength adhesive, this is dependent upon each individual installation. ie: if mounting between wall surface to wall surface.

1. Start by marking your mounting position, flange can be direct mounted on to timber, you may wish to drill pilot holes or use wall plugs (not supplied) for a secure fixing on different surfaces, simply tighten the screws until tight.

2. Apply a high strength adhesive (available separately) to the long neck and simply slide your tube into position until it sits neatly in the reception groove, wipe away any excess adhesive.

3. Allow fixative to set thoroughly, always ensure that your tube is secure before use.